16x48 Pixel Matrix Display

This started as a kit from Seasonal Entertainment, which was the power supply, controller with box, pigtails, and (16) 50 count 2811 Pixel strands.


* Three panels, each 44.8 x 46.3 outside diameter
* 2.8" center to center spacing. The spacing was expanded to provide a .15" hole to frame gap to allow for the a joining panels but you will need to confirm that this is sufficient for your pixel type.
* 3 panels
* 1" mounting braces
* 16 pixels high by 48 pixels wide
* Overall size will be determined by pixel spacing and mounting braces.
* Pixel hole size OD is .5"
* Frame and cross support size of 1"

Here are some closeup pics of the panel.

Backside, holes were the same size as the pixels, so I needed to run duct tape on the back and slit with an x-acto knife so the pixels would stay put.	Front view of the panel.		Lattice pieces used to frame the matrix together.
Edge, strain relief and pigtails for easy connections.	Controller box, E682 from SanDevices